|
|
|
|
|
|
| For
cars running 12's and well into the 7's. This kit uses 1/2" control arm bolts. **Optional 5/8" bolts available upon request. For best results and to get the suspension set up correctly for Drag Racing it is recommend that there is some way to alter the ride height of the rear of the car so the Lower Control Arms (LCA) are horizontal with the ground. Adjusting the rear ride height alters the rear control arm geometry thus moving the Instant Center (IC) forward or backward. Lengthening or shortening the IC changes the amount of leverage the suspension has to lift the nose of the car and it changes the amount of tire loading during the launches. Some ways that can be done to adjust the ride height are the use of coilovers, cutting springs or adding weight. Doing this is not necessary but it's recommended for best results. |
The Below Pictures are the Prolaunch kit installed on a Mustang.
The 12-bolt Kit installs much the same way.
|
|
|
|
|
|
For
Inquiries Send
Email To:
Kevin Slaby
tech@baselinesuspensions.com
*Please send
details about the cars
suspension, tranny, motor, tires, ET, etc
so you can be better helped.
Thank You
Copyright © 2002
Baseline Suspensions, Inc. all rights reserved.
No part of this site may be reproduced without prior written
consent.
Prices Subject to change without notice.
Prolaunch #1
