|
|
|
|
|
|
 NEW DESIGN Prolaunch #1 control arms are now Zinc Plated. These new control arms are now STANDARD EQUIPMENT in the Prolaunch #1 kits. |
| For
cars running 10's and Slower the Prolaunch #1 is
recommended. This kit uses the usual 1/2" control arm bolts and will bolt right in with little or no modifications at all. For best results and to get the suspension set up correctly for Drag Racing it is recommend that there is some way to alter the ride height of the rear of the car. Adjusting the rear ride height alters the rear control arm geometry thus moving the Instant Center (IC). Lengthening the IC changes the amount of leverage the suspension has to lift the nose of the car and it changes the amount of tire loading during the launches. Some ways that can be done to adjust the ride height are the use of coilovers, coilover conversion, weight jacker type LCA's, cutting springs or adding weight. Doing this is not necessary but it's recommended for best results. |
|
|
|
|
|
|
For
Inquiries Send
Email To:
Kevin Slaby
tech@baselinesuspensions.com
*Please send
details about the cars
suspension, tranny, motor, tires, ET, etc
so you can be better helped.
Thank You
Copyright © 2002
Baseline Suspensions, Inc. all rights reserved.
No part of this site may be reproduced without prior written
consent.
Prices Subject to change without notice.
